Chinawaterfilters - chinawaterfilters.com
General Information:
Latest News:
Extra Parts 13 Aug 2012 | 07:14 am
Extra Parts Required 30 - Gauges 25 - filter housing sumps 30 1/4" Black Bulkhead Fittings 30 1/4" White Bulkhead Fittings 30 3/8" Blue Bulkhead Fittings 30 3/8" Orange Bulkhead Fittings (Tank C...
Faucet Adaptor 16 May 2012 | 10:53 pm
Add 3/8" faucet adaptor so faucet can be used with 3/8" tube. See http://www.waterfiltersonline.com/detail.asp?product_id=John_Guest_faucet-adaptor
Check Valve 16 May 2012 | 06:05 am
There needs to be an inline check valve on the line out of the membrane housing. This will prevent the presure in the tank from being applied to the membrane in the reverse flow direction.
Materials Reports 15 May 2012 | 02:23 am
NSF or FDA approved parts certificates. SS materials certificatons.
NSF Certification 15 May 2012 | 02:20 am
NSF Certification is required for USA sales.
De-Burr All Edges清理边缘所有毛刺 2 May 2012 | 09:52 am
De-Burr All Edges - The edges must be De-Burred so they are not sharp. The new filter housing sample is De-Burred inside in the top and that is nice. But the other edges adjacent to the O-ring are ...
Labels On Front正面的LOGO 2 May 2012 | 08:19 am
Front Panel Etching - The left gauge should say "Inlet Pressure" and the right gauge should say "Membrane Pressure". Above the left filter housing should say "Sediment Pre Filter". Above the center...
RO Pressure Gauge膜压力表 2 May 2012 | 07:37 am
RO Pressure Gauge - The "Membrane Pressure Gauge" should be on the line coming into the membrane. It is currently after the membrane. This gauge is designed to read pressure drop in the first two pr...
Filter Cartridge 3不锈钢滤芯 2 May 2012 | 06:27 am
Increase the dimple in the internal plate near the botom another 1/8". After installing the gasket on the bottom this will allow 3/4" insertion into the hole on the bottom. This will be enough to acco...
Filter Cartridge 2不锈钢滤芯 2 May 2012 | 06:26 am
There are small loose wires on each end that poke the fingers. Can you use a ploisher to remove these?在不锈钢滤芯表面有松动的线头会扎到手指,打磨掉,同时滤芯底部的打磨质量要类似侧面的打磨,平整。