Freeautomechanic - freeautomechanic.com
General Information:
Latest News:
1999 Mercury Grand Prix 19 Aug 2013 | 06:05 am
I am having turn signal problems. The hazards work fine but when I use my blinker to turn left or right the front lights blink fine but the the left blinker and right blinker and brake lights all blin...
Jeep Wrangler 2006 15 Aug 2013 | 05:28 am
If a car slightly brushed against my right back flare and my bumper, not hard enough to dent anything or break anything, except for my Jeep’s bumper is slightly to the left less than a quarter inch. D...
2001 Chrysler pt cruiser 15 Aug 2013 | 03:19 am
My headlights flash at night when on high beam or low beam with driving lights on, when only low beam they are fine. Replaced switch, relay, and had alt. and battery tested. Places help?
Renault Clio 1200cc, Semi automatic Tiptronic 13 Aug 2013 | 11:16 pm
Can a Hydraulic control unit be repaired with a kit avail from Renault, mine is leaking at both ends where cable runs through. Can you get a recon HCU, I’m topping up the reservoir at present, but don...
2006 Chevrolet Silverado 1500 12 Aug 2013 | 04:12 am
Truck is accelerating on its own when there is no pressure on the gas. I tried to stop, but truck kept pulling, had to put brakes to the floor to get it to come to a stop, skidding as truck wanted to ...
2001 mazda 626 12 Aug 2013 | 04:10 am
will a computer from a 2001 mazda 626 work in my mazda 626 if the numbers are different
1996 Toyota Celica 7 Aug 2013 | 05:50 pm
Could I put a manual 1996 Lexus SC300 motor in my manual 1996 Toyota Celica?
1999 Mercury Sable 5 Aug 2013 | 06:29 pm
I can’t get it to idle down
2011 Toyota Rav4 2 Aug 2013 | 06:07 am
My Vehicle needed the rear suspension recall, I took it in and had it done, they said an alignment was needed at that time, is that typical for that recall? Also, now that my 2yr free maintenance is o...
2001 nissan pathfinder 3.5 V6 4×4 automatic 31 Jul 2013 | 08:20 pm
I am working on replacing my water pump. I have gotten all the way to removing the timing chain tensioner to produce slack, then turning the crank shaft 20 degrees counter clockwise to move that slack...
